It's an Ender 3 v3 CoreXZ. The filament sensor is on the right side. It is possible that when it reaches the right most side, it 'bends' the pfte/cables to its maximum and they put a strain? If so, how do I remedy it?
I have a Concrete slab and a rubber paver underneath. I removed them, cleaned them, put the printer back on, and reran self check. Here's the mesh now. Still a bend, but now everything is on or above the flat plane.
Not really. It actually makes sense. I often look for easy movies to watch while I do dishes. I wouldn't ever sit down to watch them, and I wouldn't want to watch good movies while doing dishes because I can't get immersed.
This is more to tweak/tune the printer to print better. I have an ender3v3, and I know it can print it without supports fine, so trying to figure out why this one can't
Thanks for the feedback. I'm doing it by the paper method, so I might be guessing the right amount of friction wrong. Is there a trick to figuring out the right amount of friction using the paper?
ah. I'll try that, thanks.